-
LDAP WebGUI v1.29.1
StableAll checks were successfulTests / shellcheck (install.sh, update.sh, bootstrap-ldap.sh, webupdate.sh, get_ldap-webgui.sh, setup.sh, config-backup.sh, certtool.sh) (push) Successful in 28sRelease / pytest (Python 3.11) (push) Successful in 6m20sRelease / pytest (Python 3.13) (push) Successful in 6m29sRelease / Publish release (push) Successful in 4sTests / pytest (Python 3.11) (push) Successful in 18m21sTests / pytest (Python 3.13) (push) Successful in 19m38sTests / pytest (Python 3.15) (push) Successful in 20m51sreleased this
2026-11-04 23:34:10 +01:00 | 10 commits to main since this releaseAdded
- The host's IP addresses in the CSR (HTTPS, LDAP server and the
combined certificate alike), so the WebUI reached by its address is
covered too. The runner records the host's global addresses (private
and ULA included; no loopback, link-local or temporary IPv6 privacy
addresses). A host with a single IPv4 address gets it as an optional
default name. Otherwise the CSR form shows the addresses as a
checkbox group: the IPv4 address of the default route — and the one
your browser is using, if it is one of the host's — pre-ticked;
IPv6 addresses only after ticking Include IPv6 addresses, never
pre-ticked. Addresses are never required; the runner refuses one that
is not the host's. Runcerttool.sh --probe(install and update do)
to record them.
Changed
- CI tests Python 3.11 (oldest supported, Debian 12) and 3.13
(Debian 13) instead of 3.11 and 3.12; the newest CPython runs as well,
an early warning for the next Debian — it gates nothing. - The release workflow publishes only after the test suite passed on the
tagged tree (3.11 and 3.13); before, a release went out even when the
tests of the same tag failed.
Fixed
/2fa/disableon an account without 2FA no longer logs
TOTP_DISABLEDor signs out the account's other sessions; it now says
there was nothing to disable.bootstrap-ldap.sh's closing summary no longer tells you to install
the WebGUI on a host that already runs it; the next steps start with
writing the config (or only the restart when--write-configalready
ran).
Update without git access: download the source tar.gz below, extract it, then run the update.sh it contains:
sudo bash <extracted-dir>/update.sh --archive <tarball>Downloads
-
Source code (ZIP)
0 downloads
-
Source code (TAR.GZ)
0 downloads
- The host's IP addresses in the CSR (HTTPS, LDAP server and the